![]() ![]() The wing is a plane wing of various sizes.Įach aviation brick has its own unique puspose. These can be attached to either a 3x3x⅔ rotor or a blade holder. The blade is a long helicopter blade, either 2x20x⅓ or 2x26x⅓. Unlike the 3x3x⅔ rotor, the blades cannot be attached directly, and require blade holders to attach. The 8x4x1 rotor is much rounder and larger, with eight holes for blade holders, and another at the bottom for the helicopter engine. The propellers must be attached directly to the 3x3x⅔ rotor. The 3x3x⅔ rotor is a small cross shape, with a hole in the bottom for the helicopter engine. The appearance of a rotor is dependent on the size. The 1x5x5 propeller is small and has only two blades, while the 1x10x10 propeller is much larger and has three blades. The appearance of a propeller is dependent on the size. ![]() The 12x8x5 helicopter engine is the largest one, and is two large cylinders with small fans on both sides, and metal cones over them. The 8x4x2 helicopter engine is very similar to the 5x2x2 helicopter engine, but is doubled in width and is much longer. An axle is located on the top, allowing a rotor to be attached on top. The 5x2x2 helicopter engine is a small trapezoidal prism with a small propeller in the front, and a vent in the back. ![]() The appearance of a helicopter engine is dependent on the size. The same brick is attached on the other side, only missing any studs or inlets. The flap is a 1x4x⅓ or 2x8x⅓ brick, similar to an actuator. The axle allows it to attach to a rotor, and the "U" shape allows blades to fit inbetween the blade holder. The blade holder is a 1x2x2 brick with an axle on one side, and the other side in a "U" shape. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |